34 Search Results

Overexpression of WRINKLED1 (WRI1), a master regulator of glycolysis and fatty acid biosynthesis, together with DIACYLGLYCEROL ACYLTRANSFERASE1 (DGAT1), which catalyzes the final step of triacylglycerol assembly, is a promising strategy for enhancing seed oil content. However, how these regulators coordinate system-wide metabolic reprogramming at the levels of gene expression, metabolite pools, and fluxes remains poorly understood. To address this, we performed ¹³C-metabolic flux analysis, metabolomics, and transcriptomics on in vitro cultured pennycress (Thlaspi arvense L.) embryos overexpressing the native WRI1 and DGAT1 homologs. Here, in cultured embryos, WRI1/DGAT1 overexpression increased triacylglycerol accumulation by 28% while reducing protein content by 34%,more » relative to the wild type. Embryos showed ∼20-fold and 50-fold upregulation of WRI1 and DGAT1 along with induction of WRI1 target genes in glycolysis and fatty acid biosynthesis. Genes associated with photosynthesis and Calvin cycle functions were also upregulated, whereas genes encoding ribosomal proteins and seed storage proteins were strongly repressed, consistent with the observed lipid–protein tradeoff. Flux analysis revealed that enhanced triacylglycerol biosynthesis is supported by increased flux through the Rubisco shunt and cytosolic pyruvate kinase, while the oxidative pentose phosphate pathway and malic enzyme contributed little to NADPH or pyruvate supply. Metabolomic profiling revealed extensive perturbations in glycolytic intermediates, tricarboxylic acid cycle metabolites, and amino acids. In plant grown seeds, WRI1/DGAT1 lines also showed a modest but significant increase in total lipid content. Collectively, these findings reveal how WRI1 and DGAT1 reprogram central metabolism to enhance oil accumulation, with relevance to mature seeds.« less

Wind energy is among the most mature renewable energy technologies, accounting for 11% of the current US electricity generation in 2024, with the lowest average levelized cost. While it is known that substantial opportunity exists for further development, a key question has been where wind energy is best suited compared to other technologies. This study leverages an immense dataset of parcel-resolved technoeconomic potential for the contiguous United States, focusing on distributed wind (DW) energy—a configuration where one or more turbines, typically 30–60 m in height are used to satisfy nearby energy needs. The analysis is conducted at multiple spatial scalesmore » and considers land use, crop land, census, and incentive program data to determine the most opportune areas for market development. The results show that rural, agricultural and residential areas are most suited to DW. Connection type (in front of, or behind the meter) and regulations determine the best application, while siting constraints, economics, demand and the wind resource determines the optimal size of turbine.« less

Presented and discussed here is the implementation of a software solution that provides prompt X-ray diffraction data analysis during fast dynamic compression experiments conducted within the dynamic diamond anvil cell technique. It includes efficient data collection, streaming of data and metadata to a high-performance cluster (HPC), fast azimuthal data integration on the cluster, and tools for controlling the data processing steps and visualizing the data using the DIOPTAS software package. This data processing pipeline is invaluable for a great number of studies. The potential of the pipeline is illustrated with two examples of data collected on ammonia–water mixtures and multiphasemore » mineral assemblies under high pressure. The pipeline is designed to be generic in nature and could be readily adapted to provide rapid feedback for many other X-ray diffraction techniques, e.g. large-volume press studies, in situ stress/strain studies, phase transformation studies, chemical reactions studied with high-resolution diffraction etc.« less

A multiyear power system R&D program was completed with the objective of developing an off-road hybrid heavy duty diesel engine with front end accessory drive-integrated energy storage. This system was validated to deliver 10.5–25.6% reduction in fuel consumption over current Tier 4 Final-based 18L diesel engines, over various off-road machine application cycles. The power system consisted of a downsized heavy-duty diesel 13L engine containing advanced combustion technologies, capable of elevated peak cylinder pressures and thermal efficiencies, thermal barrier coatings, exhaust waste heat recovery via SuperTurbo™ turbocompounding, and hybrid energy assisting and recovery through both mechanical and electrical systems. Following themore » concept definition, design, and analysis phases of the program, the final phase focused on building and validating the performance and efficiency in laboratory tests. While aspects of the system such as start/stop and reduced off-road cooling package energy losses were only analytically evaluated, the main 13L concept engine with full hybrid system was successfully built and tested in steady-state and in transient certification and real-world application cycles. Extensive simulations in Caterpillar's DYNASTY™ software environment utilized the validation test data to assess performance more fully and confidently over varied cycles and strategies. An average fuel consumption reduction of 17.9% was realized, and the majority (~13%) of the benefit stemmed from the core concept 13L engine. In conclusion, a total cost of ownership analysis provides context to commercial viability and where adoption focus should be placed.« less

Here this work presents an alternate analysis of an in vitro solubility study on the lung dissolution rate of ²³⁸PuO₂ material involved in a recent inhalation incident at Los Alamos National Laboratory (LANL). The original dataset used in this work was retrieved from a recently published report. The present work shows an analysis of the same dataset by modeling the dissolution in separate time intervals rather than modeling the cumulative dissolution.

Abstract The global decline of water quality in rivers and streams has resulted in a pressing need to design new watershed management strategies. Water quality can be affected by multiple stressors including population growth, land use change, global warming, and extreme events, with repercussions on human and ecosystem health. A scientific understanding of factors affecting riverine water quality and predictions at local to regional scales, and at sub‐daily to decadal timescales are needed for optimal management of watersheds and river basins. Here, we discuss how machine learning (ML) can enable development of more accurate, computationally tractable, and scalable models formore » analysis and predictions of river water quality. We review relevant state‐of‐the art applications of ML for water quality models and discuss opportunities to improve the use of ML with emerging computational and mathematical methods for model selection, hyperparameter optimization, incorporating process knowledge into ML models, improving explainablity, uncertainty quantification, and model‐data integration. We then present considerations for using ML to address water quality problems given their scale and complexity, available data and computational resources, and stakeholder needs. When combined with decades of process understanding, interdisciplinary advances in knowledge‐guided ML, information theory, data integration, and analytics can help address fundamental science questions and enable decision‐relevant predictions of riverine water quality.« less

The need for network connectivity in rural and underserved areas is well known. An ad hoc comparison of data throughput for various broadband technologies is reported.

When appropriately analyzed, thermoluminescent dosimeter glow curve analysis allows for improved quantification of thermoluminescent material behavior while flagging abnormalities. The mathematical separation of a glow curve into contributions from energetically unique trap states, or glow curve analysis, may be used to remove undesired effects of signal fading for complex materials. A generalized glow curve analysis software for the separation of glow curves is presented in this paper. Written in C⁺⁺, the software uses the first-order kinetics model with automatic peak identification. The automatic identification of peaks is achieved through a unique peak-finding algorithm. Here, the program was performance tested usingmore » experimental glow curve data from LiF:Mg,Ti, and comparative results are presented.« less

Measurement of the voltage delivered by an electric distribution is a relatively straight forward task. When determining the harmonic distortion in the voltage, matters associated with what orders of the 50/60 Hz harmonics to be analyzed dictate the sampling rate. A study addressing this matter is presented.